1. Home
  2. Our Work
  3. Breezaire Split System, Palo Alto

Case study · Palo Alto

New Breezaire Split System for a Palo Alto Cellar

The cellar would not go below 65°F. We found a leak in the evaporator and a clogged, cracked drain pan, and installed a new Breezaire split system.

Text a photo of your unit
A wine cellar bay seen from its doorway, with light wood racks holding bottles on both sides and a slatted back wall.
Palo Alto cellar bay, pale wood racks
System
Breezaire split system
Problem
Would not go below 65°F
What we did
New evaporator and condensing unit
Result
The cellar holds a steady 55°F

The Job in Photos

Photos from this job. Cropped and color-corrected, nothing retouched.

The wall at the niche, open and closed

  1. A beige metal cabinet on a new wood shelf inside a wall niche, with two insulated pipes wrapped in black tape running into it and a clear tube below.Open
    A metal housing on the new shelf
  2. The same niche high on a green wall, closed with a white panel held by four screws.Closed
    Closed with a white panel

The work, in order

What We Found and What We Did

The problem

The client told us the cellar would not go below 65°F. The house in Palo Alto holds a large wine collection.

Our diagnosis

Our diagnostics found two things: a leak in the evaporator, and a faulty drain. The drain pan was clogged and cracked.

The decision

The decision was to replace the whole system. The reason was the age of the system: a repair was not worthwhile.

What we did

Both halves of the system were replaced, the evaporator and the condensing unit. The new system is a Breezaire split system. The condensing unit is in the garage, and a custom niche was made for the evaporator in the wall between the cellar and the next room.

Before we started, we covered the car in the garage and the furniture next to the cellar with protective film. Jobs like these take one to three days.

The result

The cellar now holds a steady 55°F.

The Drain Pan: Clogged and Cracked

The second finding of the diagnosis: the drain pan was clogged and cracked. The water on the board inside the wall opening, in the photo marked “As found” above, came from it.

Repair or Replace? It Depends on the Type of System

The line is drawn by the type of system and by where the unit sits. Split systems are repaired. This one was replaced because of its age: a repair was not worthwhile.

  • Repair

    Split systems

    Any split system (an evaporator at the cellar and a separate condensing unit), factory-built or custom-built on site. We repair these and install new ones.

  • Repair or replace

    Self-contained units in a cellar

    We repair these too. Often a new unit is the better choice: for a repair the unit has to be taken out, then reinstalled and started again. For units older than 8 years we recommend replacement.

  • Replace

    Cabinet units and the 1800 series

    Self-contained units built into wine cabinets, and the CellarPro 1800 series wherever it is installed. We replace these rather than repair them.

Not sure which type you have?

Text us a photo of the unit and its label. We will tell you whether to repair or replace it.

Cellar Will Not Cool Down?

Call, or text us a photo of the unit. Diagnostics from $150, credited toward the job if you go ahead with us on the repair or the replacement.

  • We usually reply within the hour during business hours
  • Most visits are the same day
  • After-hours emergency service on request

Step 1 of 2Wine cellar cooling

About your system

Takes under 30 seconds. We usually reply within the hour during business hours.

What do you need? (required)
What kind of system?

We repair these. For units older than 8 years we recommend replacement.

We replace cabinet units rather than repair them. We will go over the options with you.

Step 2 of 2Wine cellar cooling

How can we reach you?

Most visits are the same day. After-hours emergency service on request.

Preferred contact method

Sending this form needs JavaScript. Please call (408) 581-2241.